Synerduino (Android)

Main Menu

• Joystick
• Accelerometer
• Settings

Definition

• Flight mode- sensitivity setting of the drone
• Sensor sensitivity – sensitivity of the phone accelerometer
• Show Progress bar – PWM data
• Block Yaw – disable Rudder command
• Aux Rename- List out the Aux switch base on FlywiiGUI (for beginers Aux 1 = Horizon & Arm Mode , this keeps the drone self leveling and as a on/off switch)
• Prevent Exit While Flying – the App wont exit until the throttle is below 1100ms
• Roll / Pitch Trims – trim your drone level

Sample of Assigning your Aux button in settings of the FlywiiGUI and Synerduino APK

SYNERDUINO – Aircraft APK

for those who wish to use this application for Vehicle operation as follows here a simple guide to safely operate. its advice that Aux 1 button is set as Arm and Horizon (pls. set this in FlywiiGUI RC Control Setting) Note: when connected this Disables your PWM from the RC Receiver as it switches over to RC Serial using the MSP Protocol

Note: compatible from Android 6 – 10 (may require install from other sources as Android may have warning as outdated Version – tested still works)

SYNERDUINO-AGV APK (Surface Vehicle only)

for those building surface Automated Guided Vehicle (Surface use) we have a special version of the app , this allow you to have a spare Phone to serve as the vehicle interface.

FLYWIIGUI (Windows)

When Setting up on FlywiiGUI modes are set as High or Low Aux 1 to 4

• Aux 1 Arm & Horizon
• Aux 2 Baro & MAG
• Aux 3 GPS Home
• Aux 4 GPS hold or Mission ,etc